CncMill
Software and Resources ← Older revision Revision as of 12:06, 24 April 2026 Line 90: Line 90: === Machine Control and G-code Validation === === Machine Control and G-code Validation === * [https://github.com/gnea/grbl GRBL] - The machine's G-code interpreter control firmware * [https://github.com/gnea/grbl GRBL] - The machine's G-code interpreter control firmware ** [https://lachiver.fr/Accueil/res/GrblPocketReference.pdf GRBL Pocket Reference ] - Two page chart of GRBL error codes, settings, and supported G-codes ** [ https://www.scribd.com/document/666309324/GrblPocketReference GRBL Pocket Reference] by Graham Bland ([https://web.archive.org/web/20260212222050/ https://lachiver.fr/Accueil/res/GrblPocketReference.pdf Wayback ] ) - Two page chart of GRBL error codes, settings, and supported G-codes * [https://winder.github.io/ugs_website Universal G-code Sender] - Our preferred machine control application. * [https://winder.github.io/ugs_website Universal G-code Sender] - Our preferred machine control application. * http://nc-corrector.inf.ua/index.html - NC-Corrector back-plots G-code to visualise the tool paths and is an interactive G-code editor. Useful for hand-writing G-code and checking it does the right thing before you run it on the mill. Runs OK on low spec laptops with old integrated graphics. * http://nc-corrector.inf.ua/index.html - NC-Corrector back-plots G-code to visualise the tool paths and is an interactive G-code editor. Useful for hand-writing G-code and checking it does the right thing before you run it on the mill. Runs OK on low spec laptops with old integrated graphics.